bayareapax.blogg.se - september 2023

Remove the clock spring and replace it with a new one.Remove the wheel and the nut so you can see the clock spring. Loosen the steering wheel nut but don't take it out completely.Mark the steering wheel's position and the steering column with two strips of painter's tape for reference to its alignment.

You can move the steering wheel to the left and right so you can remove the connectors easier.

Pull the airbag out and remove the connectors.

Open the airbag compartment by unscrewing the screws that hold it.

Disconnect the negative battery cable and leave it to allow the capacitor discharge.

Make sure that your wheel is straight and that the steering wheel is aligned forward.

Replace the malfunctioning airbag clock strings Protect yourself and your passenger at all times in case there is a crash. While the airbag may still deploy even if the warning light is on, do not be complacent. The airbag light warning signals you to fix it, so it is safe to drive your vehicle. However, an airbag doesn't also assure your safety. Without an airbag, serious injuries happen when you get into a head-on collision. This force reaches and increases the airbag, thereby protecting the driver on all sides. Next, the SRS system will signal the release of the airbags when it detects a collision.Īirbags commonly use sodium azide, which releases inert and harmless nitrogen or argon gas when ignited with a spark triggered by a collision.

If you can not find any problems there, you should really get an OBD2 scanner or let a workshop read the codes otherwise, you will be taking a stab in the dark when you try to guess the problem.When the airbag sensors detect an impending accident caused by a sudden acceleration or deceleration. Spray the connector plugs with an electronic cleaner and restart your car. In some older cars, though, it is possible to reset the airbag light without a scanner by removing the car battery terminals.Ĭheck the wiring system underneath the driver or passenger seat for any loose wires or corrosion in the connector plug. Luckily, in many car models, the airbag light will also go away by itself if you have repaired the problem. This is for safety reasons, because you should always repair the fault after the airbag light has come on. It is impossible in most car models to reset the airbag light without a scanner.

How to reset the airbag light without a scanner If the problem comes back, reread the codes and continue the procedure. If the airbag light is gone after a test drive, there is a big chance that the problem has been solved. If the airbag light seems to have gone away from your dashboard, restart your ignition and go for a test drive.